HB288064MM1 Datasheet, PDF (49/79 Pages) Hitachi Semiconductor – MultiMediaCard 64 MByte

HB288064MM1
Reset
GO_IDLE_STATE (CMD0) is the software reset command, which sets the HB288064MM1 into the Idle
State independently of the current state. In the Inactive State the HB288064MM1 is not affected by this
command. After power-on the HB288064MM1 is always in the Idle State. After power-on or command
GO_IDLE_STATE (CMD0) all output bus drivers of the HB288064MM1 is in a high-impedance state and
the card will be initialized with a default relative card address (“0x0001”). The host runs the bus at the
identification clock rate f_OD generated by a push-pull driver stage (refer to also Chapter “Power on” for
more details).
49