HB288064MM1 Datasheet, PDF (18/79 Pages) Hitachi Semiconductor – MultiMediaCard 64 MByte

HB288064MM1
• DEFAULT_ECC
Set by the card manufacturer and defines the ECC code which is recommended to use (e.g. the device is
tested for). The value is set to ‘0’, indicating that no designated ECC is recommended.
• R2W_FACTOR
Defines the typical block program time as a multiple of the read access time. The following table defines
the field format.
R2W_FACTOR
R2W_FACTOR
0
1
2
3
4
5
6, 7
Multiples of read access time
1
2 (write half as fast as read)
4
8
16
32
reserved
This parameter value is 2 for the HB288064MM1.
• WRITE_BLK_LEN
The data block length is computed as 2 . ^{WRITE_BLK_LEN}
Data Block Length
WRITE_BLK_LEN
0
1
......
11
12–15
Block length
2⁰ = 1 byte
2¹ = 2 bytes
......
2¹¹ = 2048 bytes
reserved
Remark
The block length might therefore be in the range 1, 2, 4...2048 bytes. This parameter defines the block
length if WRITE_BLK_PARTIAL is not set. If WRITE_BLK_PARTIAL is set this parameter contains the
maximum allowed value of the block length in bytes. All block lengths between one and this value are
permitted. The actual block size is programmed by the command SET_BLOCKLEN (CMD16). The
HB288064MM1 supports blocks with the length 512 bytes. The parameter WRITE_BLK_LEN is
permanently assigned to the value 0x9.
18