FH43B Datasheet, PDF (8/12 Pages) Hirose Electric – 0.2 MM PITCH, 0.9 MM ABOVE THE BOARD, FLEXIBLE PRINTED CIRCUIT ZIF CONNECTORS

FH43B Series●0.2 mm Pitch, 0.9 mm above the board, Flexible Printed Circuit ZIF Connectors
■Operation and Precautions
Operation
1. FPC insertion procedure. Connector installed on the board.
1 Lift up the actuator.
Use thumb or index finger.
2 Insert the FPC (contact surfaces facing down) at angle of
approximately 10° to the board surface ①, making sure that
the FPC positioning tabs clear the protrusions on both sides
of the connector. Lower the FPC down ②, parallel to the
board surface.
3 Rotate down the actuator until firmly closed.
FPC contact surface
faces downward
125°
①
②
Protrusions for
the FPC positioning.
2. FPC removal
1 Lift up the actuator
Pull up the FPC at an angle of approximately 10° ① and than
withdrew it from the connector ②.
125° ^②
①
Protrusions for
the FPC positioning.
8