FH43B Datasheet, PDF (1/12 Pages) Hirose Electric – 0.2 MM PITCH, 0.9 MM ABOVE THE BOARD, FLEXIBLE PRINTED CIRCUIT ZIF CONNECTORS

0.2 mm Pitch, 0.9 mm above the board, Flexible Printed Circuit ZIF Connectors
FH43B Series
Space saving
17.8mm(81 _{pos. shown)}
Can be mounted over conductive traces.
■Features
1. Low-profile, small PCB mounting area
Board footprint: Reduced approximately 45%
Weight: Reduced approximately 55%
(As compared with Hirose Electric's FH26 Series connectors
51 positions)
2. Easy solderability on the PC board
The soldering leads are on 0.4 mm pitch, exiting on front and
back of the connector.
3. Conducive traces on the PCB can run under
the connector
No exposed contacts on the bottom of the connector.
4. Easy FPC insertion and reliable electrical connection
Proven Flip Lock actuator allows easy insertion of FPC and
provides a tactile sensation when fully closed, confirming
complete electrical and mechanical connection.
5. Easy FPC/FFC insertion
FPC/FFC is self-guided in the connector assuring correct and
reliable electrical and mechanical connection.
6. Accepts standard FPC thickness
0.2mm thick standard Flexible Printed Circuit (FPC) can be
used. This is the only ultra-low profile ZIF connector using
standard FPC.
7. Board placement with automatic equipment
Flat upper surface and tape and reel packaging facilitate
vacuum pick-up and placement. Standard reel packaging
contains 5000 connectors.
No exposed contacts on the
bottom of the connector
Simple FPC insertion
actuator
FPC
Lock
Temporary hold of FPC
2010.9
1