FH43B Datasheet, PDF (12/12 Pages) Hirose Electric – 0.2 MM PITCH, 0.9 MM ABOVE THE BOARD, FLEXIBLE PRINTED CIRCUIT ZIF CONNECTORS

FH43B Series●0.2 mm Pitch, 0.9 mm above the board, Flexible Printed Circuit ZIF Connectors
Precautions
[ Removing of the FPC ]
◆Rotate the actuator to the fully open position (max. angle of 125°C)
Lift the FPC approximately 10°C (making sure that the positioning tabs clear the protrusions on both sides) and
carefully withdraw it from the connector.
125°
Protrusions for FPC positioning
[ Other Precautions ]
◆Hand Soldering Precautions
When hand soldering:
1 Do not perform reflow or hand soldering with the FPC inserted in the connector.
2 Do not apply excessive heat or touch the soldering iron anywhere other than the connector leads.
3 Do not use excessive amount of solder or flux compounds.
Operation of the actuator or contacts may be affected by excessive amounts of solder or flux compounds.
®
5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN
PHONE: [phone], FAX: [phone]
http://www.hirose.com
http://www.hirose-connectors.com
The contents of this catalog are current as of date of 09/2010. Contents are subject to change without notice for the purpose of improvements.
12