FH36 Datasheet, PDF (8/12 Pages) Hirose Electric – 0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors

FH36 Seriesq0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors
sOperation and Precautions
Operation
1. FPC insertion procedure. Connector installed on the board.
1 Lift up the actuator.
Use thumb or index finger.
2 Insert the FPC (contact surfaces facing down) at angle of
approximately 10° to the board surface ᶃ, making sure that
the FPC positioning tabs clear the protrusions on both sides
of the connector. Lower the FPC down ᶄ, parallel to the
board surface.
3 Rotate down the actuator until firmly closed.
FPC contact surface
faces downward
ᶃ
ᶄ
Protrusions for
the FPC positioning.
2. FPC removal
1 Lift up the actuator
Pull up the FPC at an angle of approximately 10° ᶃ and than with-
drew it from the connector ᶄ.
125°
ᶄ
ᶃ
Protrusions for FPC positioning
8