FH36 Datasheet, PDF (1/12 Pages) Hirose Electric – 0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors

NEW
0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors
FH36 Series
qSpace saving (51 positions shown)
2.7mm
[51 Positions]
16.9mm
sFeatures
1. Low-profile and light weight
Weight: Reduced approximately 30%
Board footprint: Reduced approximately 15%
(As compared with Hirose Electric's FH26 Series connectors
(51 positions)
2. Easy solderability on the PC board
The soldering leads are on 0.6 mm pitch, exiting on front and
back of the connector.
3. Conducive traces on the PCB can run under
the connector
No exposed contacts on the bottom of the connector.
4. Easy FPC insertion and reliable electrical
connection
Proven Flip Lock actuator allows easy insertion of FPC and
provides a tactile sensation when fully closed, confirming
complete electrical and mechanical connection.
5. FPC position hold
Tabs on each side of the FPC assure correct placement
and hold in the connector prior to closing of the actuator.
6. Accepts standard FPC thickness
0.2mm thick standard Flexible Printed Circuit (FPC) can be
used. This is the only ultra-low profile ZIF connector using
standard FPC.
7. Board placement with automatic equipment
Flat upper surface and tape and reel packaging facilitate
vacuum pick-up and placement.
Standard reel packaging contains 5,000 connectors.
8. Halogen-free ^*
(FH36W Series)
*As defined by IEC61249-2-21
Br-900ppm maximum, Cl-900ppm maximum,
Cl + Br combined-1,500ppm maximum
Metal fittings do not protrude outside of the connector body
qCan be mounted over conductive traces
No exposed contacts on the bottom of
the connector
qOperation
(1) Actuator open
(2) Insert FPC
1 ^Actuator
2
FPC
(3) Close the actuator
(4) FPC connected
3
4
qFPC temporary hold
2010.9
1