FH36 Datasheet, PDF (12/12 Pages) Hirose Electric – 0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors

FH36 Seriesq0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors
Precautions
[ Removing of the FPC ]
xRotate the actuator to the fully open position (max. angle of 125ç)
Lift the FPC approximately 10ç (making sure that the positioning tabs clear the protrusions on both sides) and
carefully withdraw it from the connector.
125°
Protrusions for FPC positioning
[ Other Precautions ]
xHand Soldering Precautions
When hand soldering:
1 Do not perform reflow or hand soldering with the FPC inserted in the connector.
2 Do not apply excessive heat or touch the soldering iron anywhere other than the connector leads.
3 Do not use excessive amount of solder or flux compounds.
Operation of the actuator or contacts may be affected by excessive amounts of solder or flux compounds.
®
5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN
PHONE: [phone], FAX: [phone]
http://www.hirose.com
http://www.hirose-connectors.com
The contents of this catalog are current as of date of 09/2010. Contents are subject to change without notice for the purpose of improvements.
12