MB82DP02183D Datasheet, PDF (7/33 Pages) Fujitsu Component Limited. – 32M Bit (2 M word × 16 bit) Mobile Phone Application Specific Memory

MB82DP02183D-65L
■ ELECTRICAL CHARACTERISTICS
1. DC CHARACTERISTICS
Parameter
Symbol
(At recommended operating conditions unless otherwise noted.)
Test conditions
Value
Unit
Min Max
Input Leakage Current
Output Leakage Current
Output High Voltage Level
Output Low Voltage Level
VDD Power Down Current
VDD Standby Current
ILI
ILO
VOH
VOL
IDDPS
IDDP4
IDDP8
IDDS
IDDS1
VSS ≤ VIN ≤ VDD
0 V ≤ VOUT ≤ VDD, Output Disable
VDD = VDD Min, IOH = −0.5 mA
IOL = 1 mA
VDD = VDD (26) Max,
VIN = VIH or VIL,
CE2 ≤ 0.2 V
Sleep
4 M-bit partial
8 M-bit partial
VDD = VDD (26) Max, VIN = VIH or VIL,
CE1 = CE2 = VIH
VDD = VDD (26) Max,
VIN ≤ 0.2 V or VIN ≥ VDD − 0.2 V,
CE1 = CE2 ≥ VDD − 0.2 V
−1.0 +1.0 µA
−1.0 +1.0 µA
2.4
⎯
V
⎯
0.4
V
⎯
10 µA
⎯
45 µA
⎯
55 µA
⎯
1.5 mA
⎯
100 µA
VDD Active Current
IDDA1
IDDA2
VDD = VDD (26) Max,
VIN = VIH or VIL,
CE1 = VIL and CE2 = VIH,
IOUT = 0 mA
tRC/tWC = Min
tRC/tWC = 1 µs
⎯
30 mA
⎯
3
mA
VDD Page Read Current
IDDA3
VDD = VDD (26) Max, VIN = VIH or VIL,
CE1 = VIL and CE2 = VIH,
IOUT = 0 mA, tPRC = Min
⎯
10 mA
Notes : • All voltages are referenced to VSS.
• IDD depends on the output termination, load conditions, and AC characteristics.
• After power on, initialization following POWER-UP timing is required. DC characteristics are guaranteed
after the initialization.
• IDDPS, IDDP4, IDDP8 and IDDS1 might be higher for up to 200ms after POWER-UP or power down/standby mode
entry.
7