MCF5282UM Datasheet, PDF (668/766 Pages) Freescale Semiconductor, Inc – MCF5282 and MCF5216 ColdFire Microcontroller User s Manual

IEEE 1149.1 Test Access Port (JTAG)
The DSCLK pin clocks the serial communication port to the debug module. Maximum frequency is 1/5
the processor clock speed. At the rising edge of DSCLK, the data input on DSI is sampled and DSO
changes state.
31.3.1.6 TDO/DSO — Test Data Output / Development Serial Output
The TDO pin is the LSB-first data output. Data is clocked out of TDO on the falling edge of TCLK. TDO
is tri-stateable and is actively driven in the shift-IR and shift-DR controller states.
The DSO pin provides serial output data in BDM mode.
31.4 Memory Map/Register Definition
31.4.1 Memory Map
The JTAG module registers are not memory mapped and are only accessible through the TDO/DSO pin.
31.4.2 Register Descriptions
All registers are shift-in and parallel load.
31.4.2.1 Instruction Shift Register (IR)
The JTAG module uses a 4-bit shift register with no parity. The IR transfers its value to a parallel hold
register and applies an instruction on the falling edge of TCLK when the TAP state machine is in the
update-IR state. To load an instruction into the shift portion of the IR, place the serial data on the TDI pin
before each rising edge of TCLK. The MSB of the IR is the bit closest to the TDI pin, and the LSB is the
bit closest to the TDO pin.
31.4.2.2 IDCODE Register
The IDCODE is a read-only register; its value is chip dependent. For more information, see
Section 31.5.3.2, “IDCODE Instruction.”
31
Field
PRN[[3:0]
28
27
Reset PRN[3] PRN[2] PRN[1] PRN[0]
R/W
DC[5:0]
0111_01
Read only
22
21
16
PIN[9:0]
PIN[9] PIN[8] PIN[7] PIN[6] PIN[5] PIN[4]
15
Field
Reset
R/W
PIN[9:0]
12
11
JEDEC[10]
0000_0000_0000_0000
Read only
Figure 31-2. IDCODE Register
1
0
ID
31-4
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
Freescale Semiconductor