MCF5282UM Datasheet, PDF (463/766 Pages) Freescale Semiconductor, Inc – MCF5282 and MCF5216 ColdFire Microcontroller User s Manual

I²C Interface
24.3.4 Acknowledge
The transmitter releases the I2C_SDA line high during the acknowledge clock pulse as shown in
Figure 24-9. The receiver pulls down the I2C_SDA line during the acknowledge clock pulse so that it
remains stable low during the high period of the clock pulse.
If it does not acknowledge the master, the slave receiver must leave I2C_SDA high. The master can then
generate a STOP signal to abort data transfer or generate a START signal (repeated start, shown in
Figure 24-10 and discussed in Section 24.3.6, “Repeated START”) to start a new calling sequence.
I2C_SCL
I2C_SDA by Transmitter
I2C_SDA by Receiver
1
2
3
4
5
6
7
8
9
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
R/W
START Signal
ACK
Figure 24-9. Acknowledgement by Receiver
If the master receiver does not acknowledge the slave transmitter after a byte transmission, it means
end-of-data to the slave. The slave releases I2C_SDA for the master to generate a STOP or START signal
(Figure 24-9).
24.3.5 STOP Signal
The master can terminate communication by generating a STOP signal to free the bus. A STOP signal is
defined as a low-to-high transition of I2C_SDA while I2C_SCL is at logical high (see F in Figure 24-7).
The master can generate a STOP even if the slave has generated an acknowledgment, at which point the
slave must release the bus. The master may also generate a START signal following a calling address,
without first generating a STOP signal. Refer to Section 24.3.6, “Repeated START.”
24.3.6 Repeated START
A repeated START signal is a START signal generated without first generating a STOP signal to terminate
the communication, as shown in Figure 24-10. The master uses a repeated START to communicate with
another slave or with the same slave in a different mode (transmit/receive mode) without releasing the bus.
Freescale Semiconductor
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
24-9