FAN54013_12 Datasheet, PDF (1/36 Pages) Fairchild Semiconductor – FAN54010 / FAN54011 / FAN54012 / FAN54013 / FAN54014

July 2012
FAN54010 / FAN54011 / FAN54012 / FAN54013 / FAN54014
USB-Compliant Single-Cell Li-Ion Switching Charger with
USB-OTG Boost Regulator
Features
 Fully Integrated, High-Efficiency Charger for Single-Cell
Li-Ion and Li-Polymer Battery Packs
 Faster Charging than Linear
 Charge Voltage Accuracy: 0.5% at 25°C
1% from 0 to 125°C
 5% Input Current Regulation Accuracy
 5% Charge Current Regulation Accuracy
 20 V Absolute Maximum Input Voltage
 6 V Maximum Input Operating Voltage
 1.45 A Maximum Charge Rate
 Programmable through High-Speed I²C Interface
(3.4 Mb/s) with Fast Mode Plus Compatibility
– Input Current
– Fast-Charge / Termination Current
– Charger Voltage
– Termination Enable
 3 MHz Synchronous Buck PWM Controller with Wide
Duty Cycle Range
 Small Footprint 1H External Inductor
 Safety Timer with Reset Control
 1.8 V Regulated Output from VBUS for Auxiliary Circuits
 Weak Input Sources Accommodated by Reducing
Charging Current to Maintain Minimum VBUS Voltage
 Low Reverse Leakage to Prevent Battery Drain to VBUS
 5 V, 500 mA Boost Mode for USB OTG for 3.0 V to
4.5 V Battery Input
Description
The FAN54010 family (FAN5401X) combines a highly
integrated switch-mode charger, to minimize single-cell Lithium-
ion (Li-ion) charging time from a USB power source, and a
boost regulator to power a USB peripheral from the battery.
The charging parameters and operating modes are
programmable through an I²C Interface that operates up to
3.4 Mbps. The charger and boost regulator circuits switch at
3MHz to minimize the size of external passive components.
The FAN5401X provides battery charging in three phases:
conditioning, constant current, and constant voltage.
To ensure USB compliance and minimize charging time, the
input current is limited to the value set through the I²C host.
Charge termination is determined by a programmable
minimum current level. A safety timer with reset control
provides a safety backup for the I²C host.
The integrated circuit (IC) automatically restarts the charge
cycle when the battery falls below an internal threshold. If the
input source is removed, the IC enters a high-impedance
mode with leakage from the battery to the input prevented.
Charge status is reported back to the host through the I²C
port. Charge current is reduced when the die temperature
reaches 120°C.
The FAN5401X can operate as a boost regulator on
command from the system. The boost regulator includes a
soft-start that limits inrush current from the battery.
The FAN5401X is available in a 1.96 x 1.87 mm, 20-bump,
0.4 mm pitch, WLCSP package.
Applications
 Cell Phones, Smart Phones, PDAs
 Tablet, Portable Media Players
 Gaming Device, Digital Cameras
All trademarks are the property of their respective owners.
Figure 1. Typical Application
© 2011 Fairchild Semiconductor Corporation
FAN5401X Family • Rev. 1.0.4
www.fairchildsemi.com