XR16M570 Datasheet, PDF (28/52 Pages) Exar Corporation – 1.62V TO 3.63V HIGH PERFORMANCE UART WITH 16-BYTE FIFO

XR16M570
1.62V TO 3.63V HIGH PERFORMANCE UART WITH 16-BYTE FIFO
REV. 1.0.0
4.4.2 Interrupt Clearing:
• LSR interrupt is cleared by a read to the LSR register.
• RXRDY interrupt is cleared by reading data until FIFO falls below the trigger level.
• RXRDY Time-out interrupt is cleared by reading RHR.
• TXRDY interrupt is cleared by a read to the ISR register or writing to THR.
• MSR interrupt is cleared by a read to the MSR register.
• Xon or Xoff interrupt is cleared by a read to the ISR register. See EMSR[7].
• Special character interrupt is cleared by a read to ISR register or after next character is received. See
EMSR[7].
• RTS# and CTS# flow control interrupts are cleared by a read to the MSR register.
• Wakeup interrupt is cleared by a read to ISR register.
]
TABLE 8: INTERRUPT SOURCE AND PRIORITY LEVEL
PRIORITY
ISR REGISTER STATUS BITS
SOURCE OF INTERRUPT
LEVEL BIT-5 BIT-4 BIT-3 BIT-2 BIT-1
BIT-0
1
0
0
0
1
1
0 LSR (Receiver Line Status Register)
2
0
0
1
1
0
0 RXRDY (Receive Data Time-out)
3
0
0
0
1
0
0 RXRDY (Received Data Ready)
4
0
0
0
0
1
0 TXRDY (Transmit Ready)
5
0
0
0
0
0
0 MSR (Modem Status Register)
6
0
1
0
0
0
0 RXRDY (Received Xon, Xoff or Special character)
7
1
0
0
0
0
0 CTS#, RTS# change of state
-
0
0
0
0
0
1 None (default) or Wakeup interrupt
ISR[0]: Interrupt Status
• Logic 0 = An interrupt is pending and the ISR contents may be used as a pointer to the appropriate interrupt
service routine.
• Logic 1 = No interrupt pending (default condition).
ISR[3:1]: Interrupt Status
These bits indicate the source for a pending interrupt at interrupt priority levels (See Interrupt Source Table 8).
ISR[4]: Interrupt Status (requires EFR bit-4 = 1)
This bit is enabled when EFR bit-4 is set to a logic 1. ISR bit-4 indicates that the receiver detected a data
match of the Xoff, Xon or special character(s).
ISR[5]: Interrupt Status (requires EFR bit-4 = 1)
ISR bit-5 indicates that CTS# or RTS# has changed state from LOW to HIGH.
ISR[7:6]: FIFO Enable Status
These bits are set to a logic 0 when the FIFOs are disabled. They are set to a logic 1 when the FIFOs are
enabled.
28