JBXFD1G05MCSDSMR Datasheet, PDF (23/44 Pages) List of Unclassifed Manufacturers – Sealed and Unsealed Push-Pull Connectors

JBX Series
Push-Pull Connectors
Cable stripping for connectors with solder contacts
Shell size
00
0
1
2
3
Ø Contact
0. 5
0. 5
0. 7
0. 9
0. 5
0. 7
0. 9
1. 3
0. 7
0. 9
1. 3
1. 6
2. 0
0. 7
0. 9
1. 3
1. 6
2. 0
Stripping for FD, SR, PC
L
S
T
9
2
4
11
2
7
12
3
7
12
3
7
12
2
8
13
3
8
13
3
8
13
3.5
8
16
3
9
16
3
9
16
3.5
9
18
4
9
18
4
9
20
3
10
20
3
10
20
3.5
10
22
4
10
22
4
10
Stripping for FC
L
S
T
-
-
-
16
2
7
16
3
7
16
3
7
19
2
8
19
3
8
19
3
8
19
3.5
8
25
3
9
25
3
9
25
3.5
9
25
4
9
25
4
9
30
3
10
30
3
10
30
3.5
10
30
4
10
30
4
10
3. When assembling a plug with a protective boot (#3), prep the cable by taking the protective boot and
sliding it with the small inside diameter first onto the cable. Then slide the end of the back nut (#2) that
has the smaller diameter onto the cable. Next, take the collet (#1) and slide the end with the gripping
teeth first onto the cable until the opposite end of the collet is flush with the cut end of the jacket. If the
cable has shielding, fold back the braid so that it is covering the outside diameter of the collet. Do not
place braid into any area of the alignment slots. Then insure that the braid does not interfere with the
alignment slots of the collet.
4. Attach removable contacts to wires:
a. If using crimped contacts, crimp the contacts onto the ends of the exposed wires using the proper crim-
ping tool set on the correct AWG wire. (see FIGURE 4.A). After the contact has been crimped to the wire,
check each contact to insure that the contact is securely crimped to the wire.
23