JBXFD1G05MCSDSMR Datasheet, PDF (18/44 Pages) List of Unclassifed Manufacturers – Sealed and Unsealed Push-Pull Connectors

JBX Series
Push-Pull Connectors
Wiring & assembly instructions
Straight plug
Cable stripping : see page 217
Connector preparation
Contact wiring : crimp contacts
Contact wiring : solder contacts
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Terminate the bucket contacts
using solder method
Connector assembly
1 - Select the proper collet . (see page 217)
2 - Slide the protective boot  the backnut
 and the collet  onto the cable.
3 - In case of a screened cable, combs out
the screen and fold back over the collet
.
1 - Select the proper crimping tool (see page
48) and locator according to the connectors
involved.
2 - Adjust the tool selector for the correspon-
ding conductor AWG.
3 - Crimp the contacts  and then engage
them into the insert cavities  till clip
tightening.
Removable solder contacts from 0.9 mm to 2 mm
1 - Solder the conductors to the contact buckets then
engage them into the insert cavities  till clip holding
1 - Position 2 half bushes  on the insert
making sure that the insert key appears
through window of one bush.
2 - Position the collet and the half bushes
while maintaining the screen. Bush keys
are seated in the collet keying slots.
3 - Position all the sub-assembly in the
connector housing  making sure to keep
sub-assembly aligned.
4 - Install the backnut  and screw it. Use the
two wrenches well positionned on the flats
A and B. Place a wrench to grip flats B, use
the other wrench to tighten the backnut at
the flats A following the torque values on
page 217.
5 - Install the protective boot  if exists.
18