HR10A-TC-02 Datasheet, PDF (20/20 Pages) List of Unclassifed Manufacturers – Push-Pull Connectors

HR10 Series●Push-Pull Connectors
■Recommended Mounting Hole
Mounting hole dimension shown here is tight by hexagon nut from back side.
Shell size
Map mark
A
B
C
Panel thickness
7 size
1.6
+0.1
0
5.1
+0.1
0
8.1
+0.1
0
0.7~2
10 size
2.6
+0.1
0
6.6
+0.1
0
11.1
+0.1
0
0.7~2
13 size
2.6
+0.1
0
8.6
+0.1
0
14.5
+0.1
0
0.8~1.5
■Contact arrangement
Shell size
7 size
10 size
Contact arrangement
No. of pins
Withstanding voltage
Current rating
Insulation resistance
Contact resistance
Solder pot inside dia.
Shell size
4
AC500V for a minute
2A
MIN 1,000Mø
MAX 10mø
Ø0.8
5
6
AC300V for a minute
2A
MIN 1,000Mø
MAX 10mø
Ø0.8
10 size
10
12
AC300V for a minute
2A
MIN 1,000Mø
MAX 10mø
Ø0.8
13 size
Contact arrangement
No. of pins
10+coaxial contact
20
Withstanding voltage
AC300V for a minute
AC300V for a minute
Current rating
2A
2A
Insulation resistance
MIN 1,000Mø
MIN 1,000Mø
Contact resistance
MAX 10mø
MAX 10mø
Solder pot inside dia.
-
Ø0.8
Note 1. The contact arrangement shown here is the mating surface of socket insert assembled in a receptacle.
2. The withstanding voltage shown here is test voltage value.
3. The isulation resistance value is measured at DC100V.
4. The contact resistance value is measured at DC1A.
■Precautions
1. Switch off the power of the circuit before disconnecting or plugging-in the connector.
2. Use a connector with socket contacts at the power side of the circuit.
3. Make sure that the coupling is in completely cocked position.
4. The cable pull and twisting strength and other characteristics may differ, deponding on the cable structure.
Please confirm vefore the use.
198