TCS37717FN Datasheet, PDF (10/48 Pages) List of Unclassifed Manufacturers – The benefits and features of the TCS3771 are listed below

TCS3771 − Electrical Characteristics
Figure 10:
Proximity Characteristics, V_DD = 3V, T_A = 25°C, Gain = 16, PEN = 1 (unless otherwise noted)
Parameter
Test Conditions Condition Min Typ Max Unit
I_DD Supply current
LDR pulse on
3
mA
ADC conversion time
step size
PTIME = 0xFF
2.27 2.4
2.56
ms
ADC number of
integration steps
1
256 steps
ADC counts per step
0
1023 counts
IR LED pulse count
0
255 pulses
LED pulse period
Two or more pulses
14
μs
LED pulse width - LED
on time
6.3
μs
PDRIVE = 0 80
106
132
LED drive current
I_SINK sink current @
PDRIVE = 1
50
mA
600mV, LDR pin
PDRIVE = 2
25
PDRIVE = 3
12.5
Dark count value
E_e = 0, PTIME = 0xFB, PPULSE = 2
900 counts
Red channel
λ_P = 850nm, E_e = 45.3μW/cm²,
PTIME = 0xFB, PPULSE = 2 ⁽¹⁾
1000
3000 counts
Clear channel
λ_P = 850nm, E_e = 45.3μW/cm²,
PTIME = 0xFB, PPULSE = 2 ⁽¹⁾
1000
3000 counts
Operating distance ⁽²⁾
30
inches
Note(s) and/or Footnote(s):
1. The specified light intensity is 100% modulated by the pulse output of the device so that during the pulse output low time, the light
intensity is at the specified level, and 0 otherwise.
2. Proximity Operating Distance is dependent upon emitter properties and the reflective properties of the proximity surface. The
nominal value shown uses an IR emitter with a peak wavelength of 850nm and a 20° half angle. The proximity surface used is a 90%
reflective (white surface) 16 × 20-inch Kodak Gray Card. 60mw/SR, 100mA, 64 pulses, open view (no glass). Greater distances are
achievable with appropriate system considerations.
Figure 11:
Wait Characteristics, V_DD = 3V, T_A = 25°C, Gain = 16, WEN = 1 (unless otherwise noted)
Parameter
Wait step size
Wait number of steps
Test Conditions
WTIME = 0xFF
Channel Min Typ Max Unit
2.27 2.4
2.56
ms
1
256 steps
Page 10
Document Feedback
ams Datasheet, Confidential
[v1-20] 2014-Aug-06