K3NR Datasheet, PDF (22/28 Pages) List of Unclassifed Manufacturers – High-speed, Intelligent Interface Modules

Power ON
RUN Mode
Press the ESC Key
and Up Key for 1 s.
• Measurement stops in Protect Mode.
• Depending on the output type of the model used, some parameters (indicated in
displayed (and hence cannot be set).
) are not
Protect Mode
Protect menu
prot
All key protection
all
1s
Set value change
prohibition
sUset
Reset prohibition
reset
(See
note.)
Displayed only for
Key-protection ON: ^kpon _{models with}
Key-protection OFF: kpoff comparative outputs.
Maximum/minimum
value reset prohibition
mm.rst
Menus protected
in Setting Mode
secr
Note: Press the Shift Key to make it
possible to set or change parameters.
Menu display
prot
Press the Mode Key
to display the parameter.
Press the ESC Key
to return to the menu.
Parameter display
all ^Setting:
Next parameter:
sUset ^Setting:
Next parameter:
reset ^Setting:
Next parameter:
mm.rst ^Setting:
Next parameter:
secr ^Setting:
Next parameter:
Meaning of parameter
Setting range
Setting key
(See note.)
All key protection:
All key operations are prohibited in
RUN Mode. (If all key protection is
ON, only the key for going to Protect
Mode is enabled.)
Set value change prohibition:
Changes to comparative set values
are prohibited in RUN Mode. (Dis-
played only for models with compara-
tive outputs.)
Reset prohibition:
Resetting using the front panel keys is
prohibited. (Resetting by external sig-
nals is not prohibited.)
Key protection ON:
Key protection OFF:
kpon
kpoff
Use the Up Key to
change the setting.
➤ kpon ➤ kpoff
Use the Mode Key
to enable the set-
ting and move to the
next parameter.
Maximum/minimum value reset prohi-
bition:
Resetting of maximum and minimum
values using the front panel keys is
prohibited. (Resetting by external sig-
nals is not prohibited.)
Menus protected in Setting Mode:
Setting operations in Setting Mode
are prohibited in the way shown be-
low.
Setting menu Setting
012
Set value menu
×
Prescaling menu
×
0 /1/2
Use the Up Key to
change the setting.
➤₀ ➤ ₁ ➤ ₂
Use the Mode Key
to enable the set-
ting and move to the
next parameter.
Setup menu
××
Option menu
×
Note: If there is no key operation for 5 seconds, the setting is automatically registered.
K-150 Frequency/Rate Meter K3NR