K3NR Datasheet, PDF (19/28 Pages) List of Unclassifed Manufacturers – High-speed, Intelligent Interface Modules

I Setting Procedures
The K3NR has four modes: RUN mode for normal operations, Setting mode for initial parameter input, Protect mode for lock-out configuration, and
Maintenance mode for initializing set values. The parameters that are accessible on any individual K3NR will vary depending on the Output Board
installed. Refer to the K3NR Operation Manual for details.
RUN Mode:
Remains in this mode under normal operation.
The process value or the max./min. value can be monitored.
Using the front panel keys, the comparative set value can be changed and max./min. value and counting value reset can
be performed.
Setting Mode:
Used for making initial settings.
Includes settings for four menus (Set value (sUset), prescaling (pscl), setup (setup), option (opt)) and the output test.
Protect Mode:
Used for locking the front key operation or parameter changes.
Maintenance Mode: Used for initializing set values.
Power ON
When power is ON
+
Maintenance mode
ESC
RUN mode
ESC
1s
ESC
Setting mode
sUset - Program set values
s.bank Select bank no. of set values
sU*.hh Enter set value HH of bank 1
sU*. h Enter set value H of bank 1
sU*. l Enter set value L of bank 1
sU*. ll Enter set value LL of bank 1
Note: The above is an example when the bank number is set to 1.
pscl - Display prescaling
p.bank Select bank no. of prescale values
ps*.ax Set the mantissa (X) of the prescale value of input A
ps*.ay Set the exponent (Y) of the prescale value of input A
ps*.bx Set the mantissa (X) of the prescale value of input B
ps*.by Set the exponent (Y) of the prescale value of input B
decp.* Select decimal point
Note: The above is an example when the bank number is set to 1.
setup - Program operating mode/input sensor/serial communications
func Specify operating mode
ina Select a sensor type of input A
inb Select a sensor type of input B
=ro.ax Set the mantissa (X) of the auto zero time of input A
=ro.ay Set the exponent (Y) of the auto zero time of input A
=ro.bx Set the mantissa (X) of the auto zero time of input B
=ro.by Set the exponent (Y) of the auto zero time of input B
opt - Supplementary settings related to display or control
aUg Set the process time for averaging measured value
stime Set startup compensation time
memo Select power failure memory function
hys Enter hysteresis value
c-out Select the output pattern
lset.h Enter the upper limit (H) of linear output range
lset.l Enter the lower limit (L) of linear output range
r-l Select the remote/local programming
test - Generating simulated input for testing the output function
+ ESC
1s
Protect mode
prot - Program lock-out configuration
all
sUset
reset
mm.rst
secr
Enable all key protection
Enable set value change prohibition
Enable prohibition of counting value reset using the front
panel keys
Enable prohibition of max./min. value reset using the
front panel keys
Specify the menus to be protected against setting in the
setting mode
time
u-no
bps
len
sbit
prty
Select the display time unit
Enter the unit no. for the host
Select the baud rate
Select the word bit length
Select the stop bits
Select the parity bits
Frequency/Rate Meter K3NR K-147