BC352239A Datasheet, PDF (21/116 Pages) List of Unclassifed Manufacturers – BlueCore 3-Multimedia External

Electrical Characteristics
Input/Output Terminal Characteristics (Continued)
Output Stage/Loudspeaker Driver
Minimum
Typical
Maximum
Unit
Output power into 32Ω
Output voltage full scale swing
Output current drive (at full scale swing)⁽⁹⁾
Output full scale current (at reduced swing)⁽⁹⁾
Distortion and noise (relative to full scale), THD
Allowed Load: resistive
Allowed Load: capacitive
-
30
-
mW pk
-
2.0
-
V pk-pk
10
20
40
mA
-
75
-
mA
-
-75
-
dBc
16
-
O.C.
Ω
-
-
500
pF
Notes:
VDD_CORE, VDD_RADIO, VDD_LO and VDD_ANA are at 1.8V unless shown otherwise.
VDD_PADS, VDD_PIO and VDD_USB are at 3.0V unless shown otherwise.
The same setting of the digital trim is applied to both XTAL_IN and XTAL_OUT.
Current drawn into a pin is defined as positive, current supplied out of a pin is defined as negative.
(1) _{Internal USB pull-up disabled.}
(2) _{Access of ADC is through VM function and therefore sample rate given is achieved as part of this}
function.
(3) _{Specified for an output voltage between 0.2V and VDD_PIO -0.2V.}
(4) _{Integer multiple of 250kHz.}
(5) _{The difference between the internal capacitance at minimum and maximum settings of the internal}
digital trim.
(6) _{XTAL frequency = 16MHz; XTAL C0 = 0.75pF; XTAL load capacitance = 8.5pF.}
(7) _{Clock input can be any frequency between 8 and 40MHz in steps of 250kHz plus CDMA/3G TCXO}
frequencies of 7.68, 14.44, 15.36, 16.2, 16.8, 19.2, 19.44, 19.68, 19.8 and 38.4MHz.
(8) _{Clock input can either be sinusoidal or square wave. If the peaks of the signal are below VSS_ANA or}
above VDD_ANA a DC blocking capacitor is required between the signal and XTAL_IN.
(9) _{For specified THD. Much greater current can be supplied by the loudspeaker driver with compromised}
THD.
BC352239A-ds-001Pc
© Cambridge Silicon Radio Limited 2004
Production Information
Page 21 of 116