HMS38112 Datasheet, PDF (19/73 Pages) List of Unclassifed Manufacturers – 4-BIT SINGLE CHIP MICROCOMPUTERS

Chapter 2.HMS39112
Pin Dimension
- NOTE -
1. DIMENSION * MARK DOES NOT INCLUDE MOLD PROTRUSION.
MAXIMUM ALLOWABLE PROTRUSION IS 0.010 INCH PER SIDE.
2. DIMENSION ** MARK DOES NOT INCLUDE MOLD PROTRUSION.
MAXIMUM ALLOWABLE PROTRUSION IS 0.010 INCH PRE SIDE.
3. UNSPECIFIED IS ACCORDING TO JEDEC MS-001 VARIATION AE.
Fig 2-3. 20PDIP (300MIL) Pin Dimension (UNIT : INCH)
- NOTE -
1. DIMENSION * MARK DOES NOT INCLUDE MOLD PROTRUSION.
MAXIMUM ALLOWABLE PROTRUSION IS 0.15 mm PER SIDE.
2. DIMENSION ** MARK DOES NOT INCLUDE MOLD PROTRUSION.
MAXIMUM ALLOWABLE PROTRUSION IS 0.25 mm PRE SIDE.
3. DIMENSIONING AND TOLERANCEING PER ANSI Y14.5M-1982.
4. UNSPECIFIED IS ACCORDING TO JEDEC MS-013, VARIATION “AC”.
Fig 2-4. 20SOP (300MIL) Pin Dimension (UNIT : mm)
2-4