EN25S64 Datasheet, PDF (50/62 Pages) Eon Silicon Solution Inc. – 64 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

EN25S64
Figure 32.1. Read Identification (RDID) under EQPI Mode
Enter OTP Mode (3Ah)
This Flash has an extra 512 bytes OTP sector, user must issue ENTER OTP MODE command to read,
program or erase OTP sector. After entering OTP mode, the OTP sector is mapping to sector 2047,
SRP bit becomes OTP_LOCK bit and can be read with RDSR command. Program / Erase command
will be disabled when OTP_LOCK bit is ‘1’
WRSR command will ignore the input data and program OTP_LOCK bit to 1.
User must clear the protect bits before enter OTP mode.
OTP sector can only be program and erase before OTP_LOCK bit is set to ‘1’ and BP [3:0] = ‘0000’ In
OTP mode, user can read other sectors, but program/erase other sectors only allowed when
OTP_LOCK bit equal to ‘0’.
User can use WRDI (04H) command to exit OTP mode.
Erase OTP Command (20h)
User can use Sector Erase (20h) command only to erase OTP data.
The instruction sequence is shown in Figure 33.1 while using the Enable Quad Peripheral Interface mode
(EQPI) (38h) command.
Table 11. OTP Sector Address
Sector
Sector Size
Address Range
2047
512 byte
7FF000h – 7FF1FFh
Note: The OTP sector is mapping to sector 2047
This Data Sheet may be revised by subsequent versions
50
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. G, Issue Date: 2011/09/23
www.eonssi.com