MB39C015 Datasheet, PDF (35/43 Pages) Cypress Semiconductor – High efficiency : 96% (Max)

MB39C015
■ Jumper information
JP
JP1
JP2
JP3
JP6
Functions
Short-circuited in the layout pattern of the board (normally used shorted).
Short-circuited in the layout pattern of the board (normally used shorted).
Normally used shorted (0 Ω)
Normally used shorted (0 Ω)
■ Setup and checkup
1. Setup
a. Connect the CTL1 terminal and the CTL2 terminal to the VCTL terminal.
b. Put it into “L” state by connecting the CTLP terminal to the AGND pad.
c. Connect the power supply terminal to the VIN terminal, and the power supply GND terminal to the PGND terminal. Make sure
PGND is connected to the PGND terminal next to the VIN terminal. (Example of setting power-supply voltage : 3.7 V)
2. Checkup
Supply power to VIN. The IC is operating normally if VOUT1 = 2.5 V (Typ) and VOUT2 = 1.8 V (Typ).
Document Number: 002-08364 Rev. *A
Page 35 of 43