English
Language : 

BCM4356XKWBGT Datasheet, PDF (116/195 Pages) Cypress Semiconductor – Single-Chip 5G WiFi IEEE 802.11ac 2×2 MAC/ Baseband/Radio with Integrated Bluetooth 4.1, FM Receiver, and Wireless Charging
BCM4356 Advance Data Sheet
Signal Descriptions
Table 22: WLBGA Signal Descriptions (Cont.)
Ball# Signal Name
J4
BT_PCM_IN
H4
BT_PCM_OUT
K6
BT_PCM_SYNC
Bluetooth USB Interface
E5
BT_USB_DN
F5
BT_USB_DP
Bluetooth UART
L5
BT_UART_CTS_L
K5
BT_UART_RTS_L
H5
BT_UART_RXD
J5
BT_UART_TXD
Bluetooth/FM I2S
J6
BT_I2S_CLK
G6
BT_I2S_DO
G5
BT_I2S_DI
L6
BT_I2S_WS
Bluetooth GPIO
A6
BT_GPIO_2
D7
BT_GPIO_3
K4
BT_GPIO_4
A7
BT_GPIO_5
Miscellaneous
A10
WL_REG_ON
D10
BT_REG_ON
L4
BT_DEV_WAKE
Type Description
I PCM data input
O PCM data output
I/O PCM sync; can be master (output) or slave (input).
I/O USB (Host) data negative. Negative terminal of the
USB transceiver.
I/O USB (Host) data positive. Positive terminal of the USB
transceiver.
I UART clear-to-send. Active-low clear-to-send signal
for the HCI UART interface.
O UART request-to-send. Active-low request-to-send
signal for the HCI UART interface. BT LED control pin.
I UART serial input. Serial data input for the HCI UART
interface.
O UART serial output. Serial data output for the HCI
UART interface.
I/O I2S clock, can be master (output) or slave (input).
I/O I2S data output
I/O I2S data input
I/O I2S WS; can be master (output) or slave (input).
I/O Bluetooth general-purpose I/O
I/O Bluetooth general-purpose I/O
I/O Bluetooth general-purpose I/O
I/O Bluetooth general-purpose I/O
I Used by PMU to power up or power down the internal
BCM4356 regulators used by the WLAN section.
Also, when deasserted, this pin holds the WLAN
section in reset. This pin has an internal 200 kΩ pull-
down resistor that is enabled by default. It can be
disabled through programming.
I Used by PMU to power up or power down the internal
BCM4356 regulators used by the Bluetooth/FM
section. Also, when deasserted, this pin holds the
Bluetooth/FM section in reset. This pin has an internal
200 kΩ pull-down resistor that is enabled by default. It
can be disabled through programming.
I/O Bluetooth DEV_WAKE
Broadcom®
May 8, 2015 • 4356-DS103-R
BROADCOM CONFIDENTIAL
Page 115