CS2100-CP_09 Datasheet, PDF(14/32 Page) Cirrus Logic

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

CS2100-CP_09 Datasheet, PDF (14/32 Pages) Cirrus Logic – Fractional-N Clock Multiplier

◁

5.1.2

CS2100-CP

Crystal Connections (XTI and XTO)

An external crystal may be used to generate RefClk. To accomplish this, a 20 pF fundamental mode par-

allel resonant crystal must be connected between the XTI and XTO pins as shown in Figure 11. As shown,

nothing other than the crystal and its load capacitors should be connected to XTI and XTO. Please refer

to the âAC Electrical Characteristicsâ on page 7 for the allowed crystal frequency range.

XTI

XTO

40 pF

Figure 11. External Component Requirements for Crystal Circuit

5.1.3

External Reference Clock (REF_CLK)

For operation with an externally generated REF_CLK signal, XTI/REF_CLK should be connected to the

reference clock source and XTO should be left unconnected or pulled low through a 47 kÎ© resistor to

GND.

5.2 Frequency Reference Clock Input, CLK_IN

The frequency reference clock input (CLK_IN) is used by the Digital PLL and Fractional-N Logic block to

dynamically generate a fractional-N value for the Frequency Synthesizer (see âHybrid Analog-Digital PLLâ

on page 12). The Digital PLL first compares the CLK_IN frequency to the PLL output. The Fractional-N logic

block then translates the desired ratio based off of CLK_IN to one based off of the internal timing reference

clock (SysClk). This allows the low-jitter timing reference clock to be used as the clock which the Frequency

Synthesizer multiplies while maintaining synchronicity with the frequency reference clock through the Digital

PLL. The allowable frequency range for CLK_IN is found in the âAC Electrical Characteristicsâ on page 7.

5.2.1

CLK_IN Skipping Mode

CLK_IN skipping mode allows the PLL to maintain lock even when the CLK_IN signal has missing pulses

for up to 20 ms (tCS) at a time (see âAC Electrical Characteristicsâ on page 7 for specifications). CLK_IN

skipping mode can only be used when the CLK_IN frequency is below 80 kHz and CLK_IN is reapplied

within 20 ms of being removed. The ClkSkipEn bit enables this function.

DS840F1

▷