AMC6821 Datasheet, PDF (6/47 Pages) Burr-Brown (TI) – Analog Monitor and Control Circuit

AMC6821
SBAS386A – MAY 2006 – REVISED MAY 2006
SMBUS INTERFACE
www.ti.com
The AMC6821 communicates through the serial system management bus (SMBus). The AMC6821 is connected
to this bus as a slave device, under the control of a bus master. The AMC6821 has a 7-bit serial bus address,
which is programmable by properly connecting the address pins A0 and A1. Table 1 shows the selection of the
AMC6821 slave address.
Table 1. AMC6821 Address Select
A0
GND
NC ⁽¹⁾
V_D
GND
NC
V_D
GND
NC
V_D
A1
GND
GND
GND
NC
NC
NC
V_D
V_D
V_D
ADDRESS
0011000
0011010
0011001
0101100
0101110
0101101
1001100
1001110
1001101
(1) NC = No connection.
Communication Protocols
The AMC6821 employs four standard SMBus protocols: the send byte, receive byte, write byte, and read byte.
All other operations result in undefined results.
Send Byte
S
SLAVE ADDRESS
WR
ACK
7-bit AMC6821 slave address
COMMAND
8-bit register address
S = start condition; P = stop condition; shaded = slave to master; unshaded = master to slave; WR = write (bit value of 0).
ACK
P
Receive Byte
S
SLAVE ADDRESS
RD
ACK
DATA
NACK
P
7-bit AMC6821 slave address
8-bit data from the register selected
previously
S = start condition; P = stop condition; shaded = slave to master; unshaded = master to slave; RD = read (bit value of 1); NACK = not acknowledged.
S
SLAVE ADDRESS
WR
7-bit AMC6821 slave address
ACK
Write Byte
COMMAND
8-bit register address
ACK
DATA
ACK
P
8-bit data written to register
S = start condition; P = stop condition; shaded = slave to master; unshaded = master to slave; WR = write (bit value of 0).
6
Submit Documentation Feedback