HCMS-2819 Datasheet, PDF (9/12 Pages) AVAGO TECHNOLOGIES LIMITED – High Performance CMOS 5x7 AlphaNumeric InGaN Blue Display

Serial/Simultaneous Data Output D₀
Bit D₀ of control word 1 is used to switch the mode of
D_OUT between serial and simultaneous data entry during
Control Register writes. The default mode (logic low) is
the serial D_OUT mode. In serial mode, D_OUT is connected
to the last bit D₇ of the Control Shift Register.
Storing logic high to bit D₀ changes D_OUT to simultane-
ous mode, which affects the Control Register only. In
simultaneous mode, D_OUT is logically connected to D_IN.
This arrangement allows multiple ICs to have their Control
Registers written to simultaneously. For example, for n
ICs in the serial mode, n * 8 clock pulses to load the same
data in all Control Registers. The propagation delay from
the first IC to the last is n * t_DOUTP.
External Oscillator Prescaler Bit D1
Bit D1 of Control Word 1 is used to scale the frequency of
an external Display Oscillator. When this bit is logic low,
the external Display Oscillator directly sets the internal
display clock rate. When this bit is a logic high, the external
oscillator is divided by 8. This scaled frequency then sets
the internal display clock rate. It takes 512 cycles of the
display clock (or 8 x 512 = 4096 cycles of an external clock
with the divide by 8 prescaler) to completely refresh the
display once. Using the prescaler bit allows the designer
to use a higher external oscillator frequency without
extra circuitry.
This bit has no affect on the internal Display Oscillator
Frequency.
Bits D2-D6
These bits must always be programmed to logic low.
Cascaded ICs
Figure 5 shows how two ICs are connected within an
HCMS-281x display. The first IC controls the four left-most
characters and the second IC controls the four right-most
characters. The Dot Registers are connected in series to
form a 320-bit dot shift register. The location of pixel 0
has not changed. However, Dot Shift Register bit 0 of IC2
becomes bit 160 of the 320-bit dot shift register.
The Control Registers of the two ICs are independent of
each other. This means that to adjust the display bright-
ness the same control word must be entered into both ICs,
unless the Control Registers are set to simultaneous mode.
Longer character string systems can be built by cascad-
ing multiple displays together. This is accomplished by
creating a five line bus. This bus consists of CE, RS, BL,
Reset, and CLK. The display pins are connected to the
corresponding bus line. Thus, all CE pins are connected
to the CE bus line. Similarly, bus lines for RS, BL, Reset, and
CLK are created. Then D_IN is connected to the right-most
display. D_OUT from this display is connected to the next
display. The left-most display receives its D_IN from the
D_OUT of the display to its right. D_OUT from the left-most
display is not used.
Each display may be set to use its internal oscillator, or
the displays may be synchronized by setting up one
display as the master and the others as slaves. The slaves
are set to receive their oscillator input from the master’s
oscillator output.
9