HCMS-2819 Datasheet, PDF (3/12 Pages) AVAGO TECHNOLOGIES LIMITED – High Performance CMOS 5x7 AlphaNumeric InGaN Blue Display

Recommend Operating Conditions Over Temperature Range (-40°C to +85°C)
Parameter
Symbol
Min.
Max.
Units
Logic Supply Voltage ^[1]
V_LOGIC
3.0
5.5
V
LED Supply Voltage ^[1]
V_LED
4.5
5.5
V
GND_LED to GND_LOGIC
-
-0.3
+0.3
V
Notes:
For further description, see Appendix B, Electrical Considerations, “VLOGIC and VLED Considerations”.
Electrical Characteristics Over Operating Temperature Range (-40°C to +85°C)
Parameter
Input Leakage Current
I_LOGIC
OPERATING
I_LOGICSLEEP ^[1]
I_LEDBLANK
I_LEDSLEEP ^[1]
Peak Pixel
Current ^[2]
Symbol
II
I_LOGIC (OPT)
I_LOGIC (SLP)
I_LED (BL)
I_LED (SLP)
I_PIXEL
T_A = 25°C,
V_LOGIC = 5.0V
Typ Max
+15
0.8
5
10
30
4.0
8.0
15.0 50
14.0 20
-40°C< T_A<85°C
3.0V<V_LOGIC<5.5V
Typ
Max
-5.0
+100
10
50
8.0
100
23
Units
PA
mA
Test Conditions
V_IN = 0 TO V_LOGIC
V_IN = V_LOGIC
PA
V_IN = V_LOGIC
mA BL = 0 V
PA
mA V_LED = 5.5 V All pixels
ON,Average value per pixel
HIGH level
V_ih
input voltage
2.0
0.8 V_LOGIC
V
4.5V<V_LOGIC<5.5V
3.0V<V_LOGIC<4.5V
LOW level
V_il
input voltage
0.8
V
0.2 V_LOGIC
4.5V<V_LOGIC<5.5V
3.0V<V_LOGIC<4.5V
HIGH level
V_oh
output voltage
2.0
0.8 V_LOGIC
V
V_LOGIC = 4.5V, Ioh = -40μA
3.0V<V_LOGIC<4.5V
LOW level
V_ol
output voltage
0.4
V
0.2 V_LOGIC
V_LOGIC = 4.5V, Ioh = -40μA
3.0V<V_LOGIC<4.5V
Thermal Resistance
RT_J-P
70
°C/W IC junction to pin
Notes:
1. In SLEEP mode, the internal oscillator and reference current for LED drivers are off.
2. Average peak pixel current is measured at the maximum drive current set by Control Register 0. Individual pixels may exceed this value.
Optical Characteristics at 25 ± 1 °C ^[1]
V_LED = 5.0V, 100% Peak Current, 100% Pulse Width
Display Color
Luminous Intensity per LED ^[2]
Character Average (μcd)
Min
Typical
Peak
Wavelength
O_Peak (nm) Typ.
Dominant
Wavelength
O_d ^[3] (nm) Typ.
Blue
29
170
456
460
Notes:
1. Refers to the initial case temperature of the device immediately prior to measurement.
2. Measured with all LEDs illuminated in a digit.
3. Dominant wavelength, ld, is derived from the CIE Chromaticity diagram and represents the single wavelength which defines the perceived LED
color.
3