AT32AP7001_1 Datasheet, PDF (315/829 Pages) ATMEL Corporation – AVR32 32-bit Microcontroller

AT32AP7001
21.8.9 SPI Chip Select Register
Name:
CSR0... CSR3
Access Type:
Read/Write
31
30
29
28
27
26
25
24
DLYBCT
23
22
21
20
19
18
17
16
DLYBS
15
14
13
12
11
10
9
8
SCBR
7
6
5
4
3
2
1
0
BITS
CSAAT
–
NCPHA
CPOL
• CPOL: Clock Polarity
0 = The inactive state value of SPCK is logic level zero.
1 = The inactive state value of SPCK is logic level one.
CPOL is used to determine the inactive state value of the serial clock (SPCK). It is used with NCPHA to produce the
required clock/data relationship between master and slave devices.
• NCPHA: Clock Phase
0 = Data is changed on the leading edge of SPCK and captured on the following edge of SPCK.
1 = Data is captured on the leading edge of SPCK and changed on the following edge of SPCK.
NCPHA determines which edge of SPCK causes data to change and which edge causes data to be captured. NCPHA is
used with CPOL to produce the required clock/data relationship between master and slave devices.
• CSAAT: Chip Select Active After Transfer
0 = The Peripheral Chip Select Line rises as soon as the last transfer is achieved.
1 = The Peripheral Chip Select does not rise after the last transfer is achieved. It remains active until a new transfer is
requested on a different chip select.
• BITS: Bits Per Transfer
The BITS field determines the number of data bits transferred. Reserved values should not be used, see Table 21-4 on
page 316.
32015G–AVR32–09/09
315