PI3039 Datasheet, PDF (9/10 Pages) AMI SEMICONDUCTOR – 600DPI CIS Image Sensor Chip

it opens just prior to the next following pixel readout. This reset is active during CP’s high
state. The disadvantage of this circuit is that it has negative going output and will have pulse
shape of the current impulse that decays over a long period. Hence, it may not be desirable
at low clock sample frequencies.
To get around this decaying type of sampling pixels, this second circuit may be more
desirable. See Figure 4B, Voltage Buffer Amplifier. This method uses the video line as
storage medium. It uses a buffer amplifier and buffers the video line with its high input
impedance. Hence, the video line effectively approaches the condition of an open circuit and
becomes a capacitance that is proportional to video line length and geometry. When the
photo site produces the signal current, it charges the video line capacitance and converts the
output into a voltage signal. The switch, SW, is a video line reset switch. It resets the video
line and the photo-site presently under interrogation, just prior to the next following pixel
readout. This reset is active during CP’s high state.
Figure 4B, Voltage Buffer Amplifier, shows the buffer amplifier configuration. The general
video wave shape and timing characteristics of this circuit are discussed under section entitled
Switching Characteristics @ 25^o C. Figure 3B, Supplement Timing Diagram, shows the
general signal wave shape and its timing relationship to the clock. Its accompanying Table 6B,
Supplement Timing Symbol's Definition, defines the symbols used in the Figure 3B. This
circuit is generally employed in CIS applications where the clock speeds are under 5.0MHz.
From all
sensor video
IOUT
SW
OP-AMP
Video
Output
RIN
RFB
Figure 4B. Voltage Buffer Amplifier
This video line charging implementation is extensively used because its simplicity and low
cost. However, speed is limited because of the video line capacitance. For any given video
line capacitance, the rate of signal charge remains the same, hence, the charging slope. As
the sampling frequency is increased, the pixel’s signal window decreases, reducing the
amplitude and at very high frequency the video sample become triangular in shape. This
effect is especially prevalent when longer line arrays are implemented. However, the CIS
modules are cascaded structure of N Image sensors in series to form various lengths of line
arrays. It is easy to see that as N increases the length of the video line on the PCB increases,
thus, increasing the video line capacitance and making it difficult to extract the signal,
especially, at high speeds.
PAGE 9 OF 10, PI3039, 12/2/02