PI3039 Datasheet, PDF (5/10 Pages) AMI SEMICONDUCTOR – 600DPI CIS Image Sensor Chip

4) For fclk < 5.0 MHz, the clock duty cycle is typically 25 %. But at fclk = 5.0 MHz or
higher a typical of 50% is recommended. This is to keep the die-to-die FPN, fixed
pattern noise, to a minimum between die transitions in CIS operation.
5) Dty is the ratio of clock pulse width over the clock period.
6) Tint at the minimum integration time is specified with a maximum clock frequency of 6.5
MHz. This specification is for a single sensor. When multiple sensors are cascaded in
series, this minimum integration time increases with each additional number of sensors.
Switching Characteristics @ 25^o C.
Since these image sensors are applied in multiple-length line array with a wide range in
scanning speeds, two types of output video amplifiers are used. Three video output circuits
are discussed under the section entitled, Output Circuits for Converting the Video Signal. But
there are only two basic types. One is current sensing amplifier and the other is charge
storing buffer amplifier. Simplified block diagrams show their interface connections with the
image sensors. They were also used to measure the specifications given in this data sheet.
The timing relationships among these two different video signals and the image sensor’s two
input clocks, its start pulse, SP, its shift register clock, CP, and its shift register output, EOS,
are shown in two diagrams, Figure 3A and its supplement, Figure 3B. The two timing
diagrams are accompanied with two tables of timing symbol’s specification. These symbols
graphically define the timing relationships among the waveforms in the timing diagrams, see
Figure 3A, Timing Diagram of the PI3039 Sensor. The switching specifications are given in
Table 6A, Timing Symbol’s Definition. Except for the analog video output, the rest are digital
clock waveforms. Their levels are +5 Volts CMOS compatible. The video signal, Iout, timing
is specified in Table 6A. Its amplitude was specified in Table 2, Electro-Optical
Characteristics.
to
tprh
tw
CP (CLOCK)
tonoff
SP (START)
tds
IOUT (VIDEO
CURRENT PULSE)
EOS (END OF
SCAN)
tdh
terdl
tdtt
FIRST
PIXEL
tdtp
tefdl
LAST
PIXEL
Figure 3A. Timing Diagram of the PI3039 Sensor
(Uses Video Output Circuit in Figure 4B)
PAGE 5 OF 10, PI3039, 12/2/02