PI3039 Datasheet, PDF (4/10 Pages) AMI SEMICONDUCTOR – 600DPI CIS Image Sensor Chip

6) Video output in dark:Vd = å Vdn/Npixels
Note: In the dark means that sensor are placed on dark target and
measured with the light off.
7) Uniformity in the dark: Ud = (Vdmax-Vdmin)
Vdmax is the maximum pixel output voltage in the dark.
Vdmin is the minimum pixel output voltage in the dark.
Absolute Maximum Ratings:
Parameters
Power Supply Voltage
Power Supply Current
VDD
IDD
Symbol
Maximum Rating
7.0
<3.0
Input clock pulse (high level)
Vih
Input clock pulse (low level)
Vil
Vdd + 0.5
-0.25
Table 3. Absolute Maximum Ratings
Environmental Ratings:
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
Top
Hop
Tstg
Hstg
0 to 50
10 to 85
-25 to 75
10 to 90
Table 4. Absolute Maximum Ratings
Units
Volts
ma
Volts
Volts
o_C
RH %
o_C
RH %
Operating Range at Room Temperature
Parameters
Power Supply
Input clock pulses high level
Input clock pulse low level
Video Signal Current (Charge for
given sample time)
Clock Frequency
Clock pulse duty cycle
Clock pulse high durations
Integration time
Operating Temperature
Symbols
VDD
Vih ⁽¹⁾
Vil ⁽¹⁾
Iout ⁽²⁾
fclk ⁽³⁾⁽⁴⁾
Dty ⁽⁵⁾
Tw
Tint ⁽⁶⁾
Top
Min Typical Max
4.5 5.0
5.5
4.0 5.0
VDD
0
0
0.8
See note.
0.1 5.0
6.5
50
100
29.54
25
50
Units
Volts
Volts
Volts
MHz
%
nsec
µsec
o_C
Table 5. Recommended Operating Condition at Room Temperature
Note
1) Applies to both CP and SP.
2) See note 3 under Table 2.
3) Although the clock frequency will operate the device at less than 100KHz, it is
recommended that the device be operated above 500KHz. This recommendation is for
long module length, such as the A4 size with 27 sequentially cascaded sensors. The
long module at low clock rates has a long scan time. This results in a long photo
integration time that generates leakage currents. The leakage currents randomly store
arbitrary amounts of charges in the photo-site, contributing to the FPN in the dark.
PAGE 4 OF 10, PI3039, 12/2/02