EN2340QI Datasheet, PDF (2/23 Pages) Enpirion, Inc. – 204A Voltage Mode Synchronous Buck PWM

Ordering Information
EN2340QI
Part Number Package Markings
EN2340QI
EN2340QI
T_AMBIENT Rating (°C)
-40 to +85
Package Description
68-pin (8mm x 11mm x 3mm) QFN T&R
EVB-EN2340QI
EN2340QI
QFN Evaluation Board
Packing and Marking Information: www.altera.com/support/reliability/packing/rel-packing-and-marking.html
Pin Assignments (Top View)
NC 1
NC 2
NC 3
NC 4
NC 5
NC 6
NC 7
NC 8
NC 9
NC 10
NC 11
NC 12
NC 13
NC 14
KEEP OUT
KEEP OUT
69
PGND
48 S_OUT
47 S_IN
46 BGND
45 VDDB
44 BTMP
43 PG
42 AVINO
41 PVIN
40 PVIN
39 PVIN
38 PVIN
37 PVIN
36 _PVIN
35 PVIN
Figure 3: Pin Out Diagram (Top View)
NOTE A: NC pins are not to be electrically connected to each other or to any external signal, ground, or voltage. All pins
including NC pins must be soldered to the PCB. Failure to follow this guideline may result in part malfunction or damage.
NOTE B: Shaded area highlights exposed metal below the package that is not to be mechanically or electrically
connected to the PCB. Refer to Figure 15 for details.
NOTE C: White ‘dot’ on top left is pin 1 indicator on top of the device package.
Pin Description
I/O Legend: P=Power
G=Ground NC=No Connect
I=Input O=Output
I/O=Input/Output
PIN NAME I/O
FUNCTION
1-15,
25-26,
59, 64-
68
NC
NO CONNECT – These pins may be internally connected. Do not connect them to each
NC other or to any other electrical signal. Failure to follow this guideline may result in device
damage.
16-24
VOUT
O
Regulated converter output. Connect these pins to the load and place output capacitor
between these pins and PGND pins 29-34.
27-28, NC(SW) NC NO CONNECT – These pins are internally connected to the common switching node of the
www.altera.com/enpirion, Page 2
06878
October 9, 2013
Rev E