ADATE305 Datasheet, PDF (19/56 Pages) Analog Devices – 250 MHz Dual Integrated DCL with Level Setting DACs, Per Pin PMU, and Per Chip VHH

ABSOLUTE MAXIMUM RATINGS
Table 14.
Parameter
Rating
Supply Voltages
Positive Supply Voltage (VDD to GND)
Positive VCC Supply Voltage (VCC to GND)
Negative Supply Voltage (VSS to GND)
Supply Voltage Difference (VDD to VSS)
Reference Ground (DUTGND to GND)
AGND to DGND
VPLUS Supply Voltage (VPLUS to GND)
Input Voltages
Input Common-Mode Voltage
Short-Circuit Voltage¹
High Speed Input Voltage²
High Speed Differential Input Voltage³
VREF
DUTx I/O Pin Current
DCL Maximum Short-Circuit Current⁴
Temperature
Operating Temperature, Junction
Storage Temperature Range
−0.5 V to +11.0 V
−0.5 V to +4.0 V
−6.25 V to +0.5 V
−1.0 V to +16.5 V
−0.5 V to +0.5 V
−0.5 V to +0.5 V
−0.5 V to +17.5 V
VSS to VDD
−3.0 V to +8.0 V
0.0 V to VCC
0.0 V to VCC
−0.5 V to +5.5 V
±140 mA
125°C
−65°C to +150°C
1 _{RL = 0 Ω, VDUT continuous short-circuit condition, (VH, VL, VT, high-Z, VCOM,}
clamp modes).
2 _{DATAxP, DATAxN, RCVxP, RCVxN, under source R = 0 Ω.}
3 _{DATAxP to DATAxN, RCVxP, RCVxN.}
4 _{RL = 0 Ω, VDUTx = –3 V to +8 V; DCL current limit. Continuous short-circuit}
condition. ADATE305 must current limit and survive continuous short circuit.
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
ADATE305
THERMAL RESISTANCE
For liquid cooled applications, θJC = 1.1°C/W.
Table 15. Thermal Resistance
Airflow
θJA
Natural Convection
33
1 meter per second
30
2 meters per second
28.5
Unit
°C/W
°C/W
°C/W
EXPLANATION OF TEST LEVELS
D Definition
S Design verification simulation
P 100% production tested
PF Functionally checked during production test
CT Characterized on tester
CB Characterized on bench
ESD CAUTION
Rev. 0 | Page 19 of 56