ACE25C200 Datasheet, PDF (9/32 Pages) ACE Technology Co., LTD. – 2MB Serial Flash Memory

ACE25C200
2MB Serial Flash Memory
Status Register Protect bit / Lock_bit (SRP/LB)
The Status Register Protect (SRP) bit is operated in conjunction with the Write Protect (WP#) signal.
The Status Register Write Protect (SRP) bit and Write Protect (WP#) signal allow the device to be put
in the Hardware Protected mode (when the Status Register Protect (SRP) bit is set to 1, and Write
Protect (WP#) is driven Low). In this mode, the non-volatile bits of the Status Register (SRP, BP2,
BP1, BP0) become read-only bits and the Write Status Register (WRSR) instruction is no longer
accepted for execution.
In OTP mode, this bit is served as Lock_bit (LB), user can read/program/erase security sector as
normal sector while LB value is equal 0, after LB is programmed with 1 by WRSR command, the
security sector is protected from program and erase operation. The LB can only be programmed once.
Note: In OTP mode, the WRSR command will ignore any input data and program LB to 1, user must clear the protect bits
before enter OTP mode and program the OTP code, then execute WRSR command to lock the security sector before
leaving OTP mode.
Status Register Memory Protection
Status Register Content
BP2 bit BP1 bit BP0 bit Protect Areas
0
0
0
None
0
0
1
0
1
0
0
1
1
1
0
0
Sector 0~47
1
0
1
Sector 0~31
1
1
0
All
1
1
1
All
Memory Content
Address
Density
None
None
Portion
None
Reserved State, not allowed
000000h~02FFFFh
000000h~01FFFFh
000000h~02FFFFh
000000h~03FFFFh
192KB
128KB
256KB
256KB
Lower 48/64
Lower 32/64
All
All
Instructions
The Standard/Dual SPI instruction set of the ACE25C200 consists of 17 basic instructions that are
fully controlled through the SPI bus (see Table 4~Table 5 Instruction Set). Instructions are initiated
with the falling edge of Chip Select (CS#). The first byte of data clocked into the DI input provides the
instruction code. Data on the DI input is sampled on the rising edge of clock with most significant bit
(MSB) first.
Instructions vary in length from a single byte to several bytes and may be followed by address bytes,
data bytes, dummy bytes (don’t care), and in some cases, a combination. Instructions are completed
with the rising edge of edge CS#. Clock relative timing diagrams for each instruction are included in
Figure 5 through Figure 27. All read instructions can be complet ed after any clocked bit. However, all
instructions that Write, Program or Erase must complete on a byte boundary (CS# driven high after a
full 8-bits have been clocked) otherwise the instruction will be ignored. This feature further protects
the device from inadvertent writes. Additionally, while the memory is being programmed or erased, or
when the Status Register is being written, all instructions except for Read Status Register will be
ignored until the program or erase cycle has completed.
VER 1.2 9