YMF715E Datasheet, PDF (42/54 Pages) YAMAHA CORPORATION – OPL3 Single-chip Audio System 3

YMF715Eɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹɹ
Hardware Volume Interrupt Channel Configuration (R/W):
Index
D7
D6
D5
D4
D3
D2
D1
D0
17h
-
-
IRQ-B MV IRQ-A MV
-
*
*
*
The Hardware Volume can source interrupt. This register indicates which interrupt
channel will be used. If IRQ-A MV=“1”, assigned to IRQ-A.
default : 00h
Notice)
Writing to the other bit positions is invalid, though the bits remarked * (D2-D0) will
retain written values. D3, D6 and D7 will always returns “0” when read.
Multi-purpose Select Pin Status (RO):
Index
D7
D6
D5
D4
D3
D2
D1
D0
18h
”1”
SEL2 SEL1 SEL0
-
-
-
“0”
This is a status register that indicates the state of multi-purpose pin.
SEL2-0...
The state of SEL2-0 pins is reflected to these bits. The multi-purpose
function of YMF715E (OPL3-SA3) can be confirmed by reading the bits.
These bits are read only.
default : (1xxx0000)_b
ɹ9-2. Joystick
port
D7
D6
D5
D4
D3
D2
D1
D0
xxh
JBB2 JBB1 JAB2 JAB1 JBCY JBCX JACY JACX
JACX... Joystick A, Coordinate X
JACY... Joystick A, Coordinate Y
JBCX... Joystick B, Coordinate X
JBCY... Joystick B, Coordinate Y
JAB1... Joystick A, Button 1
JAB2... Joystick A, Button 2
JBB1... Joystick B, Button 1
JBB2... Joystick B, Button 2
Notice)
The Joystick portion must be re-initialized by writing any value to the Joystick port after resuming
from the power down/save or the Joystick portion power down mode.
ɹ9-3. MODEM
The following pins are for MODEM interface with PnP supported.
/MCS... chip select (eight consecutive byte I/O)
MIRQ... interrupt signal
And MIN is the analog input to mix the telephone line.
MIN... analog input
May 21, 1997
-42-