W25Q16DW Datasheet, PDF (64/83 Pages) Winbond – 1.8V 16M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI

W25Q16DW
10.2.38 Set Read Parameters (C0h)
In QPI mode, to accommodate a wide range of applications with different needs for either maximum read
frequency or minimum data access latency, “Set Read Parameters (C0h)” instruction can be used to
configure the number of dummy clocks for “Fast Read (0Bh)”, “Fast Read Quad I/O (EBh)” & “Burst Read
with Wrap (0Ch)” instructions, and to configure the number of bytes of “Wrap Length” for the “Burst Read
with Wrap (0Ch)” instruction.
In Standard SPI mode, the “Set Read Parameters (C0h)” instruction is not accepted. The dummy clocks
for various Fast Read instructions in Standard/Dual/Quad SPI mode are fixed, please refer to the
Instruction Table 10.2.2-10.2.4 for details. The “Wrap Length” is set by W5-4 bit in the “Set Burst with
Wrap (77h)” instruction. This setting will remain unchanged when the device is switched from Standard
SPI mode to QPI mode.
The default “Wrap Length” after a power up or a Reset instruction is 8 bytes, the default number of
dummy clocks is 2.
P5 – P4
00
01
10
11
DUMMY
CLOCKS
2
4
6
8
MAXIMUM READ
FREQ.
50MHz
80MHz
104MHz
104MHz
P1 – P0
00
01
10
11
WRAP
LENGTH
8-byte
16-byte
32-byte
64-byte
/CS
CLK
IO₀
Mode 3
Mode 0
0123
Instruction _Read
C0h Parameters
P4 P0
Mode 3
Mode 0
IO₁
P5 P1
IO₂
P6 P2
IO₃
P7 P3
Figure 37. Set Read Parameters Instruction (QPI Mode only)
- 64 -