W25Q80DVSNIG-TR Datasheet, PDF (26/71 Pages) Winbond – 3V 8M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI

W25Q80DV
Read Data (03h)
The Read Data instruction allows one or more data bytes to be sequentially read from the memory. The
instruction is initiated by driving the /CS pin low and then shifting the instruction code “03h” followed
by a 24-bit address (A23-A0) into the DI pin. The code and address bits are latched on the rising edge
of the CLK pin. After the address is received, the data byte of the addressed memory location will be
shifted out on the DO pin at the falling edge of CLK with most significant bit (MSB) first. The address is
automatically incremented to the next higher address after each byte of data is shifted out allowing for
a continuous stream of data. This means that the entire memory can be accessed with a single
instruction as long as the clock continues. The instruction is completed by driving /CS high.
The Read Data instruction sequence is shown in figure 9. If a Read Data instruction is issued while an
Erase, Program or Write cycle is in process (BUSY=1) the instruction is ignored and will not have any
effects on the current cycle. The Read Data instruction allows clock rates from D.C. to a maximum of fR
(see AC Electrical Characteristics).
/CS
CLK
DI
(IO₀)
DO
(IO₁)
Mode 3
0
Mode 0
* ^{= MSB}
1 2 3 4 5 6 7 8 9 10
28 29 30 31 32 33 34 35 36 37 38 39
Instruction (03h)
24-Bit Address
23 22 21
*
High Impedance
3210
Data Out 1
765432107
*
Figure 9. Read Data Instruction Sequence Diagram
- 26 -
Publication Release Date:July 21, 2015
Prelimry-Revision G