W77LE58_07 Datasheet, PDF (21/82 Pages) Winbond – 8-BIT MICROCONTROLLER

W77LE58/W77L058A
XTUP: Crystal Oscillator Warm-up Status. when set, this bit indicates CPU has detected clock to be
ready. Each time the crystal oscillator is restarted by exit from power down mode or the XTOFF
bit is set, hardware will clear this bit. This bit is set to 1 after a power-on reset. When this bit is
cleared, it prevents software from setting the XT/RG bit to enable CPU operation from crystal
oscillator.
SPTA1: Serial Port 1 Transmit Activity. This bit is set during serial port 1 is currently transmitting data.
It is cleared when TI_1 bit is set by hardware. Changing the Clock Divide Control bits CD0,
CD1 will be ignored when this bit is set to 1 and SWB = 1.
SPRA1: Serial Port 1 Receive Activity. This bit is set during serial port 1 is currently receiving a data. It
is cleared when RI_1 bit is set by hardware. Changing the Clock Divide Control bits CD0,
CD1 will be ignored when this bit is set to 1 and SWB = 1.
SPTA0: Serial Port 0 Transmit Activity. This bit is set during serial port 0 is currently transmitting data.
It is cleared when TI bit is set by hardware. Changing the Clock Divide Control bits CD0, CD1
will be ignored when this bit is set to 1 and SWB = 1.
SPRA0: Serial Port 0 Receive Activity. This bit is set during serial port 0 is currently receiving a data. It
is cleared when RI bit is set by hardware. Changing the Clock Divide Control bits CD0, CD1
will be ignored when this bit is set to 1 and SWB = 1.
Timed Access
Bit:
7
TA.7
Mnemonic: TA
6
TA.6
5
TA.5
4
TA.4
3
TA.3
2
TA.2
1
TA.1
Address: C7h
0
TA.0
TA: The Timed Access register controls the access to protected bits. To access protected bits, the
user must first write AAH to the TA. This must be immediately followed by a write of 55H to TA.
Now a window is opened in the protected bits for three machine cycles, during which the user can
write to these bits.
Timer 2 Control
Bit:
7
6
5
4
3
2
1
0
TF2 EXF2 RCLK TCLK EXEN2 TR2 C / T2 CP / RL2
Mnemonic: T2CON
Address: C8h
TF2:
Timer 2 overflow flag: This bit is set when Timer 2 overflows. It is also set when the count is
equal to the capture register in down count mode. It can be set only if RCLK and TCLK are
both 0. It is cleared only by software. Software can also set or clear this bit.
EXF2: Timer 2 External Flag: A negative transition on the T2EX pin (P1.1) or timer 2 overflow will
cause this flag to set based on the CP / RL2 , EXEN2 and DCEN bits. If set by a negative
transition, this flag must be cleared by software. Setting this bit in software or detection of a
negative transition on T2EX pin will force a timer interrupt if enabled.
- 21 -
Publication Release Date: February 1, 2007
Revision A7