|
I510X Datasheet, PDF (9/16 Pages) Taiwan Memory Technology – CompactFlash Memory Card | |||
|
◁ |
Create
i510x
3. Reset voltage detector and RC oscillator
Power-on-reset and brown-out-reset
The internal reset control unit has power-on-reset (POR) and brown-out-reset (BOR) functions. To use
internal POR, set SEL_RST to 1 and RESET# must be connected to an external capacitor as shown in Fig. 3.
To use external reset signal, set SEL_RST to 0 and RESET# becomes the reset signal input.
3.3V Vdd
SEL_RST
RESET#
Cext
Figure 3. Pin connection to use internal power-on-reset/brown-out-reset
Internal RC oscillator
An integrated RC oscillator can be used to reduce BOM cost. When the internal oscillator is enabled,
ROSC must be connected to 3.3V through a resistor, as shown in Figure 4, while CLKI is not connected. The
value of Rext determines the oscillator frequency. The relationship of Rext and typical oscillator frequency is
as follows.
Rext
15Kâ¦
22Kâ¦
30Kâ¦
58Kâ¦
Fosc
50MHz
40MHz
33MHz
20MHz
3.3V Vdd
Rext
3.3V Vdd
CLKI
ROSC
SEL_CLK
Figure 4. Pin connection to use internal Oscillator
Release date: 12/9/2004
© 2004 iCreate Technologies Corporation
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 7
|
▷ |