I510X Datasheet, PDF (7/16 Pages) Taiwan Memory Technology – CompactFlash Memory Card

Create
i510x
FD0 ~ FD15
54, 55, 56, 57, 58,
59, 60, 61, 63, 66,
67, 68, 69, 70, 71,
72
70, 71, 72, 73, 74, 75,
76, 77, 80, 83, 84, 85,
86, 87, 88, 89
FALE
90
118
FCLE
89
117
FRE#, FWE#
88 , 91
116, 119
FCE0# ~
FCE7#
FCE8# ~
FCE15#
73, 74, 75, 76, 80, 93, 94, 96, 97, 104,
81, 82, 83
105, 106, 108
91, 92, 99, 100, 103,
-
110, 111, 112,
FWP#
92
120
FRDY
87
115
In/Out, 3mA
Out, 3mA
Out, 3mA
Out, 3mA
Out, 2mA
Out, 2mA
Out, 3mA
In
Flash Data Bus 0 ~ 7. Connect to flash memory
pins FD0 ~ FD7.
Flash Address Latch Enable. Connect to flash
memory pin ALE
Flash Command Latch Enable. Connect to flash
memory pin CLE
Flash Read/Write Enable. Connect to flash
memory pin RE/WE.
Flash Chip Enable. Connect to flash memory pin
CE.
Flash Chip Enable. Connect to flash memory pin
CE.
Flash Write-Protect. Connect to flash memory pin
WP.
Flash Ready/BSY signal. Connect to flash memory
pin Ready/Busy#.
System interface & power pins
Pin Name
SEL_CLK
Pin No. (100)
86
SEL_RST
77
TEST
79
RX
-
TX
-
CLKI
94
RESET#
97
Pin No. (128)
114
98
102
95
107
122
125
ROSC
99
127
REG_EN
-
67
IROM_SEL
-
90
Type
In
In
In
In
Out, 3mA
In
In
Analog In
In
In
Function
Connected to 3.3V to select internal oscillator, or
GND for external clock.
Connected to 3.3V to select internal power-on-
reset or GND for external reset
Test mode enable pin. Connected to GND.
Test pin. Connected to 3.3V or GND.
Test pin. Not connected.
Clock input
Reset input if reset is provided externally. If
SEL_RST is high, this pin is connected to GND
through a capacitor.
Connected to the same power source as VDDA
through a resistor to configure oscillator frequency
Regulator enable
Test pin. Connected to 3.3V or NC.
Release date: 12/9/2004
© 2004 iCreate Technologies Corporation
iCreate Technologies Corporation reserves the right to change the specification in any manner without notice.
Page 5