CC1350 Datasheet, PDF (9/52 Pages) Texas Instruments – SimpleLink Ultra-Low-Power Dual-Band Wireless MCU

www.ti.com
CC1350
SWRS183 – JUNE 2016
5 Specifications
5.1 Absolute Maximum Ratings
over operating free-air temperature range (unless otherwise noted)⁽¹⁾⁽²⁾
VDDS⁽³⁾ Supply voltage
Voltage on any digital pin⁽⁴⁾
MIN
MAX
UNIT
–0.3
4.1
V
–0.3
VDDS + 0.3, max 4.1
V
Voltage on crystal oscillator pins X32K_Q1, X32K_Q2, X24M_N, and X24M_P
–0.3
VDDR + 0.3, max 2.25
V
Voltage scaling enabled
–0.3
VDDS
V_in
Voltage on ADC input Voltage scaling disabled, internal reference
Voltage scaling disabled, VDDS as reference
–0.3
1.49
V
–0.3
VDDS / 2.9
Input RF level
10
dBm
T_stg
Storage temperature
–40
150
°C
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating
Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to ground, unless otherwise noted.
(3) VDDS2 and VDDS3 must be at the same potential as VDDS.
(4) Including analog-capable DIO
5.2 ESD Ratings
V_ESD Electrostatic discharge
Human body model (HBM), per ANSI/ESDA/JEDEC JS001⁽¹⁾
Charged device model (CDM), per JESD22-C101⁽²⁾
All pins
All pins
(1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.
(2) JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.
VALUE
±3000
±500
UNIT
V
5.3 Recommended Operating Conditions
over operating free-air temperature range (unless otherwise noted)
Ambient temperature
Operating supply voltage (VDDS)
Rising supply voltage slew rate
Falling supply voltage slew rate
Falling supply voltage slew rate, with low-power flash setting⁽¹⁾
Positive temperature gradient in standby⁽²⁾
For operation in battery-powered and 3.3-V
systems (internal DC-DC can be used to minimize
power consumption)
No limitation for negative temperature gradient, or
outside standby mode
MIN
MAX UNIT
–40
85
°C
1.8
3.8
V
0
100 mV/µs
0
20 mV/µs
3 mV/µs
5
°C/s
(1) For small coin-cell batteries, with high worst-case end-of-life equivalent source resistance, a 22-µF VDDS input capacitor must be used
to ensure compliance with this slew rate.
(2) Applications using RCOSC_LF as sleep timer must also consider the drift in frequency caused by a change in temperature (see 32-kHz
RC Oscillator (RCOSC_LF)).
Copyright © 2016, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: CC1350
Specifications
9