LMH0395 Datasheet, PDF (7/21 Pages) Texas Instruments – 3G HD/SD SDI Dual Output Low Power Extended Reach Adaptive Cable Equalizer

Note 3: Typical values are stated for V_CC = +2.5V and T_A = +25°C.
Note 4: Specification is guaranteed by characterization.
Note 5: The LMH0395 can be optimized for different launch amplitudes via the SPI.
Note 6: The differential output voltage and offset voltage are adjustable via the SPI.
Note 7: Typical I_CC is measured with a 2.97 Gbps input signal.
Note 8: Based on design and characterization data over the full range of recommended operating conditions of the device. Jitter is measured in accordance with
SMPTE RP 184, SMPTE RP 192, and the applicable serial data transmission standard: SMPTE 424M, SMPTE 292M, or SMPTE 259M.
Note 9: Input return loss is dependent on board design. The LMH0395 exceeds this specification on the SD395 evaluation board with a return loss network
consisting of a 5.6 nH inductor in parallel with a 75Ω series resistor on the input.
Timing Diagrams
FIGURE 1. LVDS Output Voltage, Offset, and Timing Parameters
30115708
FIGURE 2. SPI Write
30115709
FIGURE 3. SPI Read
7
30115710
www.ti.com