English
Language : 

LP3954 Datasheet, PDF (6/60 Pages) National Semiconductor (TI) – Advanced Lighting Management Unit
LP3954
SNVS340D – JUNE 2005 – REVISED MARCH 2013
www.ti.com
Electrical Characteristics(1) (2)
Limits in standard typeface are for TJ = 25° C. Limits in boldface type apply over the operating ambient temperature range (-
30°C < TA < +85°C). Unless otherwise noted, specifications apply to the LP3954 Block Diagram with: VDD1 = VDD2 = 3.6V,
VDDIO = 2.8V, CVDD = CVDDIO = 100nF, COUT = CIN = 10µF, CVDDA = 1µF, CREF = 100nF, L1 = 4.7µH, RFLASH =1.2k, RRGB =5.6k
and RRT =82k (3).
Parameter
Test Conditions
Min
Typ
Max
Unit
IVDD
Standby supply current
(VDD1, VDD2)
No-boost supply current
(VDD1, VDD2)
NSTBY = L
SCK, SS, SI
NSTBY = H,
EN_BOOST = L
SCK, SS, SI
Audio sync and LEDs OFF
1
8
µA
400
µA
No-load supply current
(VDD1, VDD2)
NSTBY = H,
EN_BOOST = H
SCK, SS, SI
Audio sync and LEDs OFF
Autoload OFF
1
mA
RGB drivers
CC mode at R1, G1, B1 and R2, G2,
150
µA
(VDD1, VDD2)
B2 set to 15mA
SW mode
150
IVDDIO
WLED drivers
(VDD1, VDD2)
Audio synchronization
(VDD1, VDD2)
Flash
(VDD1, VDD2)
VDDIO Standby Supply current
4+2 banks IOUT/LED 25mA
Audio sync ON
VDD1,2 = 2.8V
VDD1,2 = 3.6V
I(RFLASH)=1mA
Peak current during flash
NSTBY = L
SCK, SS, SI = H
500
µA
390
µA
700
2
mA
1
µA
VDDIO supply current
1MHz SCK frequency in SPI mode,
20
µA
CL = 50pF at SO pin
IEXT_LDO
VDDA
External LDO output current
(VDD1, VDD2, VDDA)
Output voltage of internal LDO
for analog parts
7V tolerant application only
IBOOST = 300mA
(4)
6.5
mA
2.72
2.80
2.88
V
-3
+3
%
(1) All voltages are with respect to the potential at the GND pins.
(2) Min and Max limits are ensured by design, test, or statistical analysis. Typical numbers are not ensured, but do represent the most likely
norm.
(3) Low-ESR Surface-Mount Ceramic Capacitors (MLCCs) used in setting electrical characteristics.
(4) VDDA output is not recommended for external use.
6
Submit Documentation Feedback
Product Folder Links: LP3954
Copyright © 2005–2013, Texas Instruments Incorporated