BQ25703A Datasheet, PDF (51/81 Pages) Texas Instruments – I2C Multi-Chemistry Battery Buck-Boost Charge Controller With System Power Monitor and Processor Hot Monitor

www.ti.com
bq25703A
SLUSCU1 – MAY 2017
Table 24. Charge Current Register (14h) With 10-mΩ Sense Resistor (I2C address = 02h) Field
Descriptions (continued)
I2C
02h
FIELD
6
Charge Current, bit 0
5-0 Reserved
TYPE
R/W
R/W
RESET
0b
000000b
DESCRIPTION
0 = Adds 0 mA of charger current.
1 = Adds 64 mA of charger current.
Not used. Value Ignored.
8.6.3.1 Battery Pre-Charge Current Clamp
During pre-charge, BATFET works in linear mode or LDO mode (default REG0x00[2] = 1). For 2-4 cell battery,
the system is regulated at minimum system voltage in REG0x0D/0C() and the pre-charge current is clamped at
384 mA. For 1 cell battery, the pre-charge to fast charge threshold is 3 V, and the pre-charge current is clamped
at 384 mA. However, the BATFET stays in LDO mode operation till battery voltage is above minimum system
voltage (~3.6 V). During battery voltage from 3 V to 3.6 V, the fast charge current is clamped at 2 A.
Copyright © 2017, Texas Instruments Incorporated
Submit Documentation Feedback
51