English
Language : 

THS6032_14 Datasheet, PDF (5/35 Pages) Texas Instruments – LOW-POWER ADSL CENTRAL-OFFICE LINE DRIVER
◁
THS6032
www.ti.com....................................................................................................................................................... SLOS233F – APRIL 1999 – REVISED AUGUST 2009
ELECTRICAL CHARACTERISTICS (continued)
At VCC(L) = ±5 V, VCC(H) = ±15 V, RL = 25 Ω, and TA = +25°C (unless otherwise noted).
THS6032
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
OUTPUT CHARACTERISTICS
VO
Output voltage
IO
Output current(3)
ISC
Short-circuit current(3)
POWER SUPPLY
Single-ended
Differential
RL = 25 Ω
RL = 50 Ω
RL = 25 Ω
±10.5
±11
V
±21
±22
400
440
mA
800
mA
VCC
Supply voltage
ICC
Quiescent current (per amplifier)
VCC(L)
VCC(H)
VCC(L)
VCC(H)
TA = +25°C
TA = full
range
TA = +25°C
TA = full
range
0
±5 ±VCCH
V
±5
±15 ±16.5
4.3
5.8
6.2 mA
4
5
5.5 mA
PSRR
Power-supply rejection ratio
TA = +25°C
90
100
VCC(L)
TA = full
80
dB
range
TA = +25°C
69
80
VCC(H)
TA = full
66
dB
range
SHUTDOWN CHARACTERISTICS
VIL
Shutdown voltage for power up
Relative to DGND terminal
VIH
Shutdown voltage for power down
Relative to DGND terminal
IIH
Shutdown input current high
V(SHDN) = 5 V
IIL
Shutdown input current low
V(SHDN) = 0.5 V
ZO
Output impedance (while in shutdown state)
V(SHDN) = 2.5 V, f = 1 MHz
ICCL
ICCH
tdis
ten
Supply current (per amplifier) (while in shutdown state) V(SHDN) = 2.5 V, VO = 0 V
Disable time(4)
Enable time(4)
2
200
20
0.5
0.05
2.4
1.1
1.5
0.8 V
V
300 μA
40 μA
Ω
0.2
mA
3
μs
μs
(3) A heat sink is required to keep junction temperature below absolute maximum when an output is heavily loaded or shorted. See
Absolute Maximum Ratings table.
(4) Disable/enable time begins when the logic signal is applied to the shutdown terminal and ends when the supply current has reached half
of its final value.
Copyright © 1999–2009, Texas Instruments Incorporated
Product Folder Link(s): THS6032
Submit Documentation Feedback
5
 ▷