TM4C1237D5PM Datasheet, PDF (333/1264 Pages) Texas Instruments – Floating-Point Status Control (FPSC)

Tiva^™ TM4C1237D5PM Microcontroller _{(identical to LM4F130C4QR)}
Register 62: Synchronous Serial Interface Run Mode Clock Gating Control
(RCGCSSI), offset 0x61C
The RCGCSSI register provides software the capability to enable and disable the SSI modules in
Run mode. When enabled, a module is provided a clock and accesses to module registers are
allowed. When disabled, the clock is disabled to save power and accesses to module registers
generate a bus fault. This register provides the same capability as the legacy Run Mode Clock
Gating Control Register n RCGCn registers specifically for the watchdog modules and has the
same bit polarity as the corresponding RCGCn bits.
Important: This register should be used to control the clocking for the SSI modules. To support
legacy software, the RCGC1 register is available. A write to the RCGC1 register also
writes the corresponding bit in this register. Any bits that are changed by writing to the
RCGC1 register can be read back correctly with a read of the RCGC1 register. Software
must use this register to support modules that are not present in the legacy registers.
If software uses this register to write a legacy peripheral (such as SSI0), the write causes
proper operation, but the value of that bit is not reflected in the RCGC1 register. If
software uses both legacy and peripheral-specific register accesses, the
peripheral-specific registers must be accessed by read-modify-write operations that
affect only peripherals that are not present in the legacy registers. In this manner, both
the peripheral-specific and legacy registers have coherent information.
Synchronous Serial Interface Run Mode Clock Gating Control (RCGCSSI)
Base 0x400F.E000
Offset 0x61C
Type R/W, reset 0x0000.0000
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
reserved
Type RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
reserved
R3
R2
R1
R0
Type RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
R/W
R/W
R/W
R/W
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Bit/Field
31:4
3
Name
reserved
R3
Type
RO
R/W
Reset
0
0
Description
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
SSI Module 3 Run Mode Clock Gating Control
Value Description
1 Enable and provide a clock to SSI module 3 in Run mode.
0 SSI module 3 is disabled.
2
R2
R/W
0
SSI Module 2 Run Mode Clock Gating Control
Value Description
1 Enable and provide a clock to SSI module 2 in Run mode.
0 SSI module 2 is disabled.
July 16, 2013
333
Texas Instruments-Production Data