English
Language : 

TMS320F28030_16 Datasheet, PDF (32/160 Pages) Texas Instruments – Piccolo Microcontrollers
TMS320F28030, TMS320F28031, TMS320F28032
TMS320F28033, TMS320F28034, TMS320F28035
SPRS584K – APRIL 2009 – REVISED JUNE 2016
www.ti.com
5.11 Power Sequencing
There is no power sequencing requirement needed to ensure the device is in the proper state after reset
or to prevent the I/Os from glitching during power up/down (GPIO19, GPIO34–38 do not have glitch-free
I/Os). No voltage larger than a diode drop (0.7 V) above VDDIO should be applied to any digital pin prior to
powering up the device. Voltages applied to pins on an unpowered device can bias internal p-n junctions
in unintended ways and produce unpredictable results.
VDDIO, VDDA
(3.3 V)
VDD (1.8 V)
INTOSC1
tINTOSCST
X1/X2
tOSCST
(B)
(A)
XCLKOUT
(D)
XRS
Address/Data/
Control
(Internal)
Boot-Mode
Pins
I/O Pins
tw(RSL1)
User-code dependent
Address/data valid, internal boot-ROM code execution phase
td(EX)
th(boot-mode)(C)
User-code execution phase
User-code dependent
GPIO pins as input
Boot-ROM execution starts
(E)
GPIO pins as input (state depends on internal PU/PD)
Peripheral/GPIO function
Based on boot code
User-code dependent
A. Upon power up, SYSCLKOUT is OSCCLK/4. Since the XCLKOUTDIV bits in the XCLK register come up with a reset
state of 0, SYSCLKOUT is further divided by 4 before it appears at XCLKOUT. XCLKOUT = OSCCLK/16 during this
phase.
B. Boot ROM configures the DIVSEL bits for /1 operation. XCLKOUT = OSCCLK/4 during this phase. Note that
XCLKOUT will not be visible at the pin until explicitly configured by user code.
C. After reset, the boot ROM code samples Boot Mode pins. Based on the status of the Boot Mode pin, the boot code
branches to destination memory or boot code function. If boot ROM code executes after power-on conditions (in
debugger environment), the boot code execution time is based on the current SYSCLKOUT speed. The SYSCLKOUT
will be based on user environment and could be with or without PLL enabled.
D. Using the XRS pin is optional due to the on-chip power-on reset (POR) circuitry.
E. The internal pullup/pulldown will take effect when BOR is driven high.
Figure 5-6. Power-on Reset
32
Specifications
Copyright © 2009–2016, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TMS320F28030 TMS320F28031 TMS320F28032 TMS320F28033 TMS320F28034
TMS320F28035