LM3560 Datasheet, PDF (30/42 Pages) Texas Instruments – LM3560 Synchronous Boost Flash Driver w/ Dual 1A High-Side Current Sources (2A Total Flash Current)

ADC DELAY REGISTER (Address 0x31)
The ADC Delay Register programs the delay from when the
EOC bit goes low to when a conversion is initiated. This delay
applies to both Manual Mode and Automatic Mode. Bit 5 is
the No Delay bit and can set the delay to effectively 0.
TABLE 10. ADC Delay Register Descriptions
Bit 7
(Not
Used)
N/A
Bit 6
Bit 5 (No Delay)
(Not used)
Bit 4 (D1)
Bit 3 (D2) Bit 2 (D3) Bit 1 (D4) Bit 0 (D5)
0 = Delay is set by bits [4:0]
Bits [4:0] programs the delay from when the EOC bit goes low to when
(default)
a conversion is started (250 µs/step).
1 = no delay from when the EOC ^{00000 = 250 µs}
goes low to when the conversion is ^:
started.
01111 = 4 ms (default)
:
11111 = 8 ms
VIN MONITOR REGISTER (Address 0x80)
The VIN Monitor Register controls the Enable bit for the VIN
Monitor, the threshold select for the VIN Monitor, the enable
bit for the VIN Flash Monitor, and the threshold select for the
VIN Flash Monitor (see Table 11).
TABLE 11. VIN Monitor Register Descriptions
Bit 7
(Not used)
N/A
Bit 6
(Not used)
Bit 5
(VIN Flash
Monitor
Threhold 1)
Bit 4
(VIN Flash
Monitor
Threhold 2)
00= 2.9V (default)
01 = 3.0V
10 = 3.1V
11 = 3.2V
Bit 3
Bit 2
Bit 1
Bit 0
(VIN Flash (VIN Monitor (VIN Monitor (VIN Monitor
Monitor Threshold1) Threshold0)
Enable)
enable)
0 = VIN Flash 00 = 2.9V Default
0 = VIN Monitor
Monitor is 01= 3.0V
disabled 10 = 3.1V
disabled (default)
(default) 11 = 3.2V
1 = VIN Flash
1 = VIN Monitor is
Monitor is
enabled
enabled
29
www.national.com