LM3560 Datasheet, PDF (24/42 Pages) Texas Instruments – LM3560 Synchronous Boost Flash Driver w/ Dual 1A High-Side Current Sources (2A Total Flash Current)

I²C-Compatible Interface
START AND STOP CONDITIONS
The LM3560 is controlled via an I²C-compatible interface.
START and STOP conditions classify the beginning and end
of the I²C session. A START condition is defined as SDA
transitioning from HIGH-to-LOW while SCL is HIGH. A STOP
condition is defined as SDA transitioning from LOW-to-HIGH
while SCL is HIGH. The I²C master always generates the
START and STOP conditions.
FIGURE 17. Start and Stop Sequences
30113818
The I²C bus is considered busy after a START condition and
free after a STOP condition. During data transmission the
I²C master can generate repeated START conditions. A
START and a repeated START condition are equivalent func-
tion-wise. The data on SDA must be stable during the HIGH
period of the clock signal (SCL). In other words, the state of
SDA can only be changed when SCL is LOW. Figure 18
shows the SDA and SCL signal timing for the I²C-Compatible
Bus. See the Electrical Table for timing values.
FIGURE 18. I²C-Compatible Timing
23
301138119
www.national.com